JUKI LU-2810 - 10. ATTACHING AND REMOVING THE BOBBIN; 11. THREADING THE HOOK

– 12 –
10. ATTACHING AND REMOVING THE BOBBIN
1) Liftlatch
❶
ofhook,andtakeoutthebobbin.
2) Putthebobbinintotheshaftinthehookcorrect-
lyandreleasethelatch.
1. Do not make the machine run idle with
the bobbin (bobbin thread). The bobbin
thread is caught in the hook. As a result,
the hook may be damaged.
2. Be careful so as not to get hurt with the
top end of the counter knife.
11. THREADING THE HOOK
1) Passthethreadthroughthreadpath
❶
in the
hookandthreadhole
❷
inthelever,anddraw
thethread.
 Now,thethreadwillbebroughttothreadhole
❷
viathetensionspring.
2) Makesurethatthebobbinrevolvesinthedirec-
tionofthearrowwhenyoudrawthethread.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❶
❶
❷