JUKI LU-2810 - 3. ADJUSTING THE BELT TENSION (LU-2810, LU-2860); 4. ATTACHING THE BELT COVER (LU-2810, LU-2860)

–5–
3. ADJUSTING THE BELT TENSION (LU-2810, LU-2860)
Adjust thebelt tension with the height of the motor
so that the belt sags 15 mm when the center of V
beltisappliedwitha9.8Nload.
15mm
Motor pulley
Handwheel
9.8N
4. ATTACHING THE BELT COVER (LU-2810, LU-2860)
(Installationprocedure)
1) PuttheV-beltonthesewingmachinepulley.
2) Installbeltcover
❶
onthemachinearm.
3) InstallbeltcoverB
❷
onthetable.
4) Mountthehandlesectionofthepulleywitha
screw.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❶
❷
V-belt