JUKI LU-2860 - Needle lifting switch; 2 P switch; Needle thread tension changeover switch

–30–
❸
Needle lifting switch
Ifthisswitchispressed,themachinewilltravelfromtheneedle-downstoppositiontotheneedle-upstopposition.
When raising the machine head which has been tilted, do not hold the operation switch to raise it.
❹
2P switch
 Ifthisswitchispressed,thestitchlengthis
changedovertothatofthescaleonthe2Pfeed
adjustingdial.(Lampinthebuttonislitup.)
Be sure to make the number of 2P feed
adjusting dial less than that of the standard
feed adjusting dial.
Example
・
Standard feed adjusting dial scale : 9
・
2P feed adjusting dial scale : 6
・
If this switch is pressed, stitch length is changed
over from 9 to 6.
OFF ON
・
If this switch is pressed again, stitch length
returns from 6 to 9.
❺
Needle thread tension changeover switch
 Whentheswitchispressed,thedoubletensionfunctionisselectedtoincreasetheneedlethreadten-
sion.(Thelampabovetheswitchislitup.)
❻
 ThisisnotusedfortheLU-2810-7and-2860-7.