16
Threading preparations / Tips
1. Extend the retractable support rod tted with open
thread guide as far as it goes.
2. Raise the presser foot. (Tension disk opens.)
3. Open the looper cover.
4. Turn the power on.
Threading sequence
The thread guides can be threaded in any sequence.
The threading sections are color coded correspondingly.
Threading the thread guide No. 1
Bring down the thread which is put on the retractable support
rod to thread the thread guide No. 1 from its left side. Then,
route the thread downward to bring it toward you.
Lower looper thread (red markings)
Upper looper thread (purple markings)
Right needle thread (green markings)
Left needle thread (beige markings)
To Next Page
Loading...
