What to do if my JUKI MO-50e Sewing Machine does not sew?
If your JUKI Sewing Machine isn't sewing, start by checking that the cord is correctly plugged in. Also, verify that the main switch is turned on to '1'.
How to fix poor stitch formation on my JUKI MO-50e Sewing Machine?
If you notice poor stitch formation with your JUKI Sewing Machine, the thread might not be correctly wound around the tension dials. Double-check the threading to ensure it's properly set up.
Why are the seams fluting on my JUKI MO-50e Sewing Machine (knits)?
If the seams on your knits are fluting or waving when using your JUKI Sewing Machine, the differential feed is likely set incorrectly. Try adjusting the differential feed between N and 8.
Why are the fabric edges curling when using my JUKI MO-50e Sewing Machine?
If the fabric edges are curling when using your JUKI Sewing Machine, there might be too much fabric in the stitch formation. Reduce the cutting width by moving the knife to the left.
Why are the thread loops loose on my JUKI MO-50e?
If you notice loose thread loops on your JUKI Sewing Machine, it indicates there is too little fabric in the stitch formation. Increase the cutting width by moving the knife to the right.
Why does the thread keep breaking on my JUKI MO-50e Sewing Machine?
If the thread breaks on your JUKI Sewing Machine, it could be due to several reasons. First, the thread tension might be too tight; try reducing it. Second, the machine may not be threaded correctly, so double-check the threading. Finally, ensure that the needles are correctly inserted fully into the needle clamp with the flat side to the back.
Why do the needles keep breaking on my JUKI Sewing Machine?
Needle breakage in your JUKI Sewing Machine can occur for a few reasons. Make sure to replace the needles if they are bent, blunt, or damaged. Also, ensure needles are fully inserted into the needle clamp with the flat side to the back. Avoid pulling the fabric while sewing; instead, gently guide the fabric with both hands.
Why are the seams puckering on my JUKI MO-50e?
Seams puckering on your JUKI Sewing Machine? This could be happening because the differential feed is set incorrectly. Try adjusting the differential feed between N and 5.
Why do seams flute or ware when sewing knits on my JUKI Sewing Machine?
If seams flute or ware when working with knits on your JUKI Sewing Machine, the differential feed may be set incorrectly. Adjust the differential feed between N and 8.
How to prevent fabric edges from curling on my JUKI MO-50e Sewing Machine?
If the fabric edges are curling when using your JUKI Sewing Machine, there might be too much fabric in the stitch formation. Try reducing the cutting width by adjusting the knife to the left.
General| Type | Overlock |
|---|---|
| Number of Threads | 3/4 |
| Stitch Length | 1 - 4 mm |
| Differential Feed Ratio | 0.7 - 2.0 |
| Maximum Sewing Speed | 1300 stitches per minute |
| Needle System | 130/705H |
| Presser Foot Lift | 5 mm |
| Motor Power | 90 W |
| Needle Size | 11-14 |
To Next Page
