Julabo F32-ME - 9.5. MENU CONTROL - Control characteristics and parameters

ME
9.5. MENU CONTROL – Control characteristics and parameters
Menu level 1

The circulator is qualified for internal and external temperature control
The switchover is carried out in the menu >C-TYPE< .(INT or EXT).
 For external temperature control and measurement connect a Pt100
external sensor to the socket at the rear of the circulator.
 Press the key if a parameter is to be retained. Correction function
for parameters or values (prior to OK)
Level 2 Parameter level

or
• Switchover of control type by pressing
and
 The control type can be adjusted in the -OFF-
mode only.
 Depending on the adjustment only the active
parameters are displayed.
C-TYPE INTERNAL

or
• The parameter flashes, switch by pressing
and
 This parameter affects the temperature sequence
in case of internal control.

0.1 … 99.9
• The parameter flashes, set by pressing
+

3 … 9999
•
The parameter flashes, set by pressing
+

0 … 999
•
The parameter flashes, set by pressing
+
C-TYPE EXTERNAL

0.1 … 99.9
•
The parameter flashes, set by pressing
+

3 … 9999
•
The parameter flashes, set by pressing
+
41
w ww. . com
information@itm.com1.800.561.8187