Julabo FK30-SL - Page 87

SL
87
Command Parameter Response of circulator
IN_PAR_08
none Tv control parameter of the internal controller.
IN_PAR_09
none Xp control parameter of the cascade controller.
IN_PAR_10
none Proportional share of the cascade controller.
IN_PAR_11
none Tn control parameter of the cascade controller.
IN_PAR_12
none Tv control parameter of the cascade controller.
IN_PAR_13
none Adjusted maximum internal temperature of the cascade
controller.
IN_PAR_14
none Adjusted minimum internal temperature of the cascade
controller.
IN_PAR_15
none Band limit (upper)
IN_PAR_16
none Band limit (lower)
IN_MODE_01
none Selected setpoint:
0 = Setpoint 1
1 = Setpoint 2
2 = Setpoint 3
IN_MODE_02
none Selftuning type:
0 = Selftuning “off”
1 = Selftuning “once”
2 = Selftuning “always”
IN_MODE_03
none Type of external programmer input:
0 = Voltage 0 V to 10 V
1 = Current 0 mA to 20 mA
IN_MODE_04
none
Internal/external temperature control:
0 = Temperature control with internal sensor.
1 = Temperature control with external Pt100 sensor.
IN_MODE_05
none
Circulator in stop/start condition:
0 = stop
1 = start
IN_MODE_08
none
Adjusted control dynamics
0 = aperiodic
1 = standard
IN_HIL_00
none Max. cooling power (%).
IN_HIL_01
none Max. heating power (%).