Julabo FP51-SL - Page 4

4
9.4.4.
Off-Mode ............................................................................................................ 46
9.4.5. ActVar - actuating variable .................................................................................. 47
9.4.6. Setting of clock and date .................................................................................... 48
9.4.7. Language ........................................................................................................... 48
9.4.8. Unit ..................................................................................................................... 48
9.4.9. Program type ...................................................................................................... 48
9.4.10. Reset ............................................................................................................. 48
9.5. Control .................................................................................................................... 49
9.5.1. Control internal / external ................................................................................... 51
9.5.2. Selftuning ........................................................................................................... 52
9.5.3. Dynamik intern ................................................................................................... 52
9.5.4. CoSpeed - extern ............................................................................................... 53
9.5.5. Control parameters – internal/external ................................................................ 53
9.6. Serial Interface ........................................................................................................ 55
9.7. ATC Absolute Temperature Calibration, 3-point calibration ..................................... 56
9.7.1. ATC Fühler - intern / extern ................................................................................ 59
9.7.2. ATC Status - yes / no ......................................................................................... 59
9.7.3. Type 1 -/ 2 -/ 3 point .......................................................................................... 59
9.7.4. Example: 3-point calibration for internal control ................................................. 60
9.8. Limits ...................................................................................................................... 62
9.8.1. Limits for internal control and external control..................................................... 63
9.8.2. Limits for external control.................................................................................... 64
9.9. Analog inputs/outputs ............................................................................................. 65
9.9.1. Control connector ............................................................................................... 69
9.9.2. Outputs of the connector - REG+E-PROG .......................................................... 70
9.9.3. Input of the connector - REG+E-PROG .............................................................. 71
9.9.4. External Stand-by input ...................................................................................... 73
9.9.5. Alarm-output ....................................................................................................... 74
10. Troubleshooting guide / Error messages ..................................................................... 75
11. Electrical connections .................................................................................................. 78
12. Remote control ............................................................................................................ 81
12.1. Setup for remote control .......................................................................................... 81
12.2. Communication with a PC or a superordinated data system ................................... 81
12.3. List of commands .................................................................................................... 82
12.4. Status messages .................................................................................................... 86
12.5. Error messages....................................................................................................... 86
13. Installation of electronic module with analog connectors ............................................. 87
14. JULABO Service – Online remote diagnosis ............................................................... 88
15. Cleaning / repairing the unit ......................................................................................... 89
16. WARRANTY PROVISIONS ......................................................................................... 90