Preparations
5. Preparations
5.1. Installation
• Place the circulator in an upright position.
• Place the unit on an even surface on a pad made of non-
flammable material
5.2. Bath fluids
Carefully read the safety data sheet of the bath fluid used, particularly with
regard to the fire point!
If a bath fluid with a fire point of ≤65 °C is used, only supervised operation is
possible.
Water: The quality of water depends on local conditions.
• Due to the high concentration of lime, hard water is not suitable for
temperature control because it leads to calcification in the bath.
• Ferrous water can cause corrosion - even on stainless steel.
• Chloric water can cause pitting corrosion.
• Distilled and deionized water is unsuitable. Their special properties cause
corrosion in the bath, even in stainless steel.
Recommended bath fluids:
See website for list of recommended bath fluids.
ATTENTION: The maximum permissible viscosity is 50 mm
2
/s
16
To Next Page