7
86/87R Compressor System User Guide 6190755 (Rev A)
© 2015, JUN-AIR
We reserve the right to make any alterations which may be due to any technical improvements
Printed in the USA
Pressure vessel
Pressure tested at: All sizes:
Directions for use
Application Receiver for compressed air.
Receiver specifications See name plate.
Installation Tubes, etc. must be installed with
suitable materials.
Placement Observe the working temperature
of the receiver.
Ensure sufficient room for inspection
and maintenance.
The receiver must be kept in a
horizontal position.
Corrosion protection The surface treatment must be
maintained as required.
Internal inspection at least every
5 years.
Drain condensate at least once a week.
Alternation/repair No welding must be made on
pressurised parts.
Safety valve Ensures that PS rating will not be
exceeded.
Never adjust to a higher pressure
than PS.
The capacity of the valve must be
calculated in accordance with the
volume of air supplied by the
compressor.
(PS = Maximum working pressure
of the receiver. This is specified on the
system's serial number label.)
16.5 - 24BAR
To Next Page
Loading...
