Jungheinrich Easy Access Transponder Stand-Alone - Activating the Module with Default Code; Blocking the Module

To Next Page

To Previous Page

2.2 Using the Display:

2.2.1 Activating the Module with the Default Code

Procedure

• Release the emergency disconnect switch.

• Enter the default code 1-2-3-4 using the soft keys below the display (3).

The module is enabled.

2.2.2 Blocking an Enabled Module

Procedure

• Press the key under the "Switch off" symbol (5) on the

display unit.5

The module is blocked.

As an option, the customer service department can pre-set the module such that the

module is blocked automatically after a defined delay at a standstill. Automatic

blocking does not occur if the module has been enabled by the set-up code or the

set-up transponder.