EasyManua.ls Logo

Jungheinrich EFG 216 - User Manual

Jungheinrich EFG 216
243 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
09.09 -
03.13
51151902
EFG 213-320
Operating instructions G
EFG 316
EFG 215
EFG 216k
EFG 216
EFG 218k
EFG 218
EFG 220
EFG 316k
EFG 318k
EFG 318
EFG 320
EFG 213

Table of Contents

Questions and Answers

  • D
    Dr. Nicole BuchananAug 9, 2025
    What to do if my Jungheinrich EFG 216 truck does not start?
    • H
      hunterbergerAug 9, 2025
      If your Jungheinrich Forklift doesn't start, several factors could be at play. Ensure the battery connector is properly plugged in. Check that the EMERGENCY DISCONNECT is not pressed. The key switch should be in the “I” position. Also, verify the battery charge and charge if necessary. Make sure the battery door is closed, and the on-board charger is not active. Finally, inspect the fuses for any faults.
  • R
    Richard CohenAug 18, 2025
    What to do if I see an error message displayed on Jungheinrich Forklifts?
    • J
      Jeffrey RobertsAug 18, 2025
      If you see an error message displayed on your Jungheinrich Forklifts, try pressing the EMERGENCY DISCONNECT isolator or turning the key switch to 0. Wait approximately 3 seconds, and then attempt the operation again.
  • Z
    zmurphyAug 29, 2025
    Why my Jungheinrich Forklifts load cannot be lifted?
    • P
      pearsonmelodyAug 30, 2025
      If your Jungheinrich Forklifts cannot lift a load, first ensure the truck is operational by checking the points listed under “Truck does not move.” Also, verify that the hydraulic oil level is adequate and inspect the fuses for any issues.

Summary

B Truck Description

Technical Specifications

C Transport and Commissioning

D Battery - Servicing, Recharging, Replacement

Safety Regulations for Lead-Acid Batteries

Charging the Battery

Explains procedures for charging with stationary and on-board chargers, including safety warnings.

Battery Removal and Installation

Step-by-step guides for safely removing and installing batteries using various equipment.

E Operation

Safety Regulations for Forklift Operation

Essential safety rules for drivers, covering authorization, hazards, and general conduct.

Displays and Controls Overview

Details the truck's dashboard displays, control panel, and operator interfaces.

Preparing the Truck for Operation

Covers pre-operation checks, entry/exit, seat adjustment, and system setup.

Industrial Truck Operation

Guidance on travel conduct, hazardous areas, load handling, and specific maneuvers.

F Industrial Truck Maintenance

Operational Safety and Environmental Protection

Maintenance and Repairs Procedures

Servicing and Inspection Intervals

Jungheinrich EFG 216 Specifications

General IconGeneral
BrandJungheinrich
ModelEFG 216
CategoryForklifts
LanguageEnglish

Related product manuals