EasyManua.ls Logo

Jungheinrich EFG 220 - User Manual

Jungheinrich EFG 220
243 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
09.09 -
03.13
51151902
EFG 213-320
Operating instructions G
EFG 316
EFG 215
EFG 216k
EFG 216
EFG 218k
EFG 218
EFG 220
EFG 316k
EFG 318k
EFG 318
EFG 320
EFG 213

Table of Contents

Questions and Answers

  • E
    Elizabeth DanielAug 9, 2025
    What to do if my Jungheinrich EFG 220 truck does not start?
    • T
      Timothy FreemanAug 9, 2025
      If your Jungheinrich Forklift doesn't start, several factors could be at play. Ensure the battery connector is properly plugged in. Check that the EMERGENCY DISCONNECT is not pressed. The key switch should be in the “I” position. Also, verify the battery charge and charge if necessary. Make sure the battery door is closed, and the on-board charger is not active. Finally, inspect the fuses for any faults.
  • E
    Eric MatthewsAug 18, 2025
    What to do if I see an error message displayed on Jungheinrich Forklifts?
    • B
      Brenda LeeAug 18, 2025
      If you see an error message displayed on your Jungheinrich Forklifts, try pressing the EMERGENCY DISCONNECT isolator or turning the key switch to 0. Wait approximately 3 seconds, and then attempt the operation again.
  • C
    Clinton FullerAug 28, 2025
    Why my Jungheinrich Forklifts load cannot be lifted?
    • S
      Shirley BeckAug 29, 2025
      If your Jungheinrich Forklifts cannot lift a load, first ensure the truck is operational by checking the points listed under “Truck does not move.” Also, verify that the hydraulic oil level is adequate and inspect the fuses for any issues.

Jungheinrich EFG 220 Specifications

General IconGeneral
Load Capacity2000 kg
Overall Width1150 mm
Drive TypeElectric
Battery Voltage48 V
Travel Speed16 km/h

Related product manuals