03.13 EN
200
10.2 Customer service
10.2.1 Standard equipment
Brakes W A B C
1 Test brakes. t
2 Check magnetic brake air gap. t
3 Check brake mechanism, adjust and lubricate if necessary. t
Electrical System W A B C
1 Test cable and motor attachments. t
2
Test warning and safety devices in accordance with operating
instructions.
t
3 Test displays and controls. t
4 Test micro switch and adjust if necessary. t
5 Test Emergency Disconnect switch. t
6 Check contactors and/or relays. t
7 Test fan and check for dirt and damage. t
8 Check fuse ratings. t
9 Carry out a frame leakage test. t
10
Check electric wiring for damage (insulation damage, connections).
Make sure wire connections are secure.
t
Power Supply W A B C
1
Check battery cable connections are secure, grease terminals if
necessary.
t
2 Check battery and battery components. t
3 Check acid density and battery voltage. t
4
Check battery connector for damage, test it and make sure it is
secure.
t
5 Check safety labelling is present. t
Travel W A B C
1
Check transmission oil level or grease filling of the transmission and
top up if necessary.
t
2 Check transmission for noise and leakage. t
3 Note: Replace transmission oil after 10000 service hours.
4
Check the wheels for wear and damage. Make sure they are tight
and check the compressed air if necessary.
t
5 Check wheel suspension and attachment. t