What to do if the engine oil indicator is lit during operation in Jungheinrich Forklifts?
If the engine oil indicator is lit during operation, it indicates that the engine oil level is too low. Check the engine oil level and top it up if necessary.
What to do if the starter does not turn in Jungheinrich Forklifts?
If the starter doesn't turn, it could be due to several reasons: * The travel direction switch might not be in neutral. Turn the travel direction switch to neutral. * The battery charge might be too low. Check the battery charge and charge the battery if necessary. * The battery terminal cable could be loose or the terminals oxidized. Clean and grease the terminals, then tighten the battery terminal cable. * The starter cable might be loose or broken. Check the starter cable, and tighten or replace it as required. * The starter magnetic switch might be jammed. Check if the magnetic switch audibly engages.
What to do if the engine temperature display is in the red zone in Jungheinrich TFG 435 Forklifts?
If the engine temperature display is in the red zone, it could indicate several problems: * The engine oil level might be too low; check and top up if necessary. * The radiator might be contaminated; clean it. * The coolant level might be too low; check the engine radiator system for leaks and add coolant if necessary. * The fan V-belt might be slipping; check the V-belt tension and tighten or replace it as required.
What to do if the transmission oil indicator is lit during operation in Jungheinrich Forklifts?
If the transmission oil indicator is lit during operation, it suggests that the transmission oil level is too low. Check the transmission oil level and top up if necessary. Also, the radiator might be contaminated, so ensure you clean it.
What to do if the Jungheinrich TFG 435 engine is running but the truck does not travel?
If the engine is running but the truck isn't moving, ensure that the travel direction switch is set to the required direction and that the parking brake is released.
Why is the lift speed too low in Jungheinrich Forklifts?
If the lift speed is too low, it could be due to: * A hydraulic reservoir oil level that is too low. Check the hydraulic oil and top up if necessary. * A hydraulic reservoir discharge system that is contaminated or blocked. Clean or replace the hydraulic reservoir discharge system.
What to do if the load cannot be raised to maximum height in Jungheinrich TFG 435 Forklifts?
If the load cannot be raised to the maximum height, it is likely that the hydraulic reservoir oil level is too low. Check the hydraulic oil and top up if necessary.
What to do if the engine does not start in Jungheinrich Forklifts?
If the engine doesn't start, several issues could be the cause: * The air filter might be contaminated, so you should clean or replace it. * The Bowden cable could be faulty or hanging, requiring a check. * The LPG bottle shutoff valve might be closed, so ensure it's open. * The LPG bottle may be empty, requiring a replacement. * The ignition distributor cap could be damp; dry it and apply contact spray if needed. * Spark plugs might be damp, oily, or loose; dry, clean, and tighten them. * The spark plugs could be faulty, so replace them. * The fuel tank might be empty, with the injection system having suctioned in air; fill up with diesel and bleed the injection system. * There could be water in the fuel system; discharge the fuel system and add fuel. * The fuel filte...
Explains symbols and warnings used for safety instructions.
Details permissible operating environments, temperatures, and inclines.
Explains data plates and how to read capacity plates for safe operation.
Crucial safety rules for handling diesel and LPG fuels to prevent accidents.
Essential safety rules for operating the forklift truck, including driver authorization.
Covers safe travel, load handling, and attachment operation.
Rules for personnel and procedures related to safe maintenance and repair work.
Outlines the schedule and types of service checks required for the truck.
Guide to diagnosing and fixing common operational issues using fault displays.
General| Load Capacity | 3500 kg |
|---|---|
| Mast Type | Triplex |
| Lowering Speed (loaded) | 0.55 m/s |
| Tire Type | Pneumatic |
| Power Type | LPG |
| Turning Radius | 2450 mm |
To Next Page