EasyManua.ls Logo

Jungheinrich TFG 435s - User Manual

Jungheinrich TFG 435s
229 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DFG/TFG 425s / 435s
G
10.07-
Operating Instructions
51077936 ► 51209061
01.09 ► 03.13

Table of Contents

Questions and Answers

  • M
    michaelmelendezAug 19, 2025
    Why Jungheinrich TFG 435s engine oil indicator lit during operation?
    • P
      pmcmahonAug 19, 2025
      The engine oil indicator might light up during operation because the engine oil level is too low. Check the engine oil level and top it up if needed.
  • E
    Emily AdamsAug 22, 2025
    What to do if my Jungheinrich Forklifts starter does not turn?
    • C
      Courtney MolinaAug 22, 2025
      If the starter doesn't turn, here are some things to check: * The battery charge might be too low. Check the battery charge and charge the battery if necessary. * The battery terminal cable might be loose or the terminals oxidized. Clean and grease the terminals, then tighten the battery terminal cable. * The starter cable might be loose or broken. Check the starter cable and tighten or replace it as required. * The starter solenoid might be jammed. Check if the magnetic switch audibly engages.
  • E
    Emily FisherAug 26, 2025
    Why Jungheinrich TFG 435s Forklifts overtemperature indicator lit?
    • J
      Jennifer RojasAug 26, 2025
      If the overtemperature indicator is lit, it could be due to several reasons: * The engine oil level might be too low. Check the engine oil level and top it up if necessary. * The radiator might be contaminated. Clean the radiator. * The coolant level might be too low. Check the engine radiator system for leaks and add coolant if necessary. * The fan V belt might be slipping. Check the V belt tension and tighten or replace it as required.
  • M
    Michael NelsonAug 28, 2025
    Why Jungheinrich TFG 435s Forklifts truck does not reach max. speed?
    • D
      Dwayne FloydAug 28, 2025
      If the truck isn't reaching its maximum speed, it could be because the hydraulic reservoir oil level is too low. Check the hydraulic oil and top it up if necessary.
  • P
    Paula Osborne DDSAug 31, 2025
    What to do if Jungheinrich TFG 435s Forklifts steering is sluggish?
    • B
      Bonnie SpencerAug 31, 2025
      If the steering feels sluggish, check the steering axle tire pressure and increase it to the correct pressure if necessary.
  • B
    barberericSep 3, 2025
    Why Jungheinrich Forklifts lift speed too low?
    • M
      Manuel SotoSep 3, 2025
      If the lift speed is too low, consider these possible causes: * The hydraulic reservoir oil level might be too low. Check the hydraulic oil and top it up if necessary. * The hydraulic reservoir discharge system might be contaminated or blocked. Replace the hydraulic reservoir discharge system.
  • J
    James CrawfordSep 6, 2025
    Why Jungheinrich TFG 435s Forklifts engine running but truck does not travel?
    • N
      Nicholas RodriguezSep 6, 2025
      If the engine is running but the truck won't move, it could be due to: * The travel direction switch being in neutral. Set the travel direction switch to the desired direction. * The parking brake being applied. Release the parking brake.
  • M
    Michael NovakSep 9, 2025
    What causes excessive steering play in Jungheinrich Forklifts?
    • W
      Wanda AguirreSep 9, 2025
      Excessive steering play can be caused by air in the steering system. Check the hydraulic oil level, top up if necessary, and then turn the steering wheel several times from one end to the other.
  • A
    Alexander PhamSep 12, 2025
    Why Jungheinrich TFG 435s Forklifts load cannot be raised to max. height?
    • J
      Jeffery ElliottSep 12, 2025
      If the load cannot be raised to the maximum height, the hydraulic reservoir oil level might be too low. Check the hydraulic oil and top it up if necessary.
  • W
    William NewmanNov 15, 2025
    What to do if my Jungheinrich TFG 435s Forklifts engine does not start?
    • S
      Sandra NelsonNov 15, 2025
      If the engine doesn't start, consider these potential causes: * The air filter might be contaminated. In this case, clean or replace the air filter. * The fuel tank could be empty, or the injection system might have suctioned in air. Refill with diesel and bleed the injection system. * There might be water in the fuel system. If so, discharge the fuel system and refill the truck. * The fuel filter could be contaminated. Check the fuel flow and replace the fuel filter if necessary. * Paraffin separation from the diesel might have occurred (flakes forming). Park the truck in a warm room until the separation returns to its original state, and replace the fuel filter if needed, filling with winter diesel. * The LPG bottle shutoff valve might be closed. Open the shutoff valve. * ...

Summary

A Correct Use and Application

B Truck Description

E Operation

1 Safety Regulations for the Operation of the Forklift Truck

Essential safety rules and driver authorization for operating the truck.

2 Displays and Controls

Identification and function of the truck's displays and control elements.

3 Preparing the Truck for Operation

Steps to prepare the truck for daily operation and checks.

Troubleshooting

7.1 Troubleshooting

Procedures for localizing and rectifying basic faults in the truck's operation.

F Industrial Truck Maintenance

1 Operational Safety and Environmental Protection

Safety and environmental considerations during maintenance activities.

4 Maintenance and repairs

Detailed procedures for performing maintenance and repairs on the truck.

Servicing and Inspection

Jungheinrich TFG 435s Specifications

General IconGeneral
BrandJungheinrich
ModelTFG 435s
CategoryForklifts
LanguageEnglish

Related product manuals