11.14 EN
210
Road traffic approval (StVZO)
Boom
Weigher sensors / switches
Wiper/washer system
Fork positioner
Access module
Electrical System W A B C
1 Test lighting. t
Hydraulic operations W A B C
1
Check attachment is properly secured to the truck and the
supporting elements.
t
Electrical System W A B C
1 Test weigher system and check for damage. t
Chassis and Superstructure W A B C
1
Check wiper water container for leaks and check volume, top up if
necessary.
t
2 Test windscreen wipers and check for damage, replace if necessary. t
Hydraulic operations W A B C
1 Test the hose reel and check for leaks and damage. t
2 Check axial play of the front and rear rollers and adjust if necessary. t
3
Check attachment is properly secured to the truck and the
supporting elements.
t
4 Test attachment, check settings and check for damage. t
5 Check sliding blocks are complete. t
6
Check attachment bearing points, guides and stops for wear and
damage, grease and clean these components.
t
7 Check attachment lubrication; clean and lubricate if necessary. t
8 Check hydraulic ports and tighten if necessary. t
9 Test the fork positioner and check for damage. t
10 Check cylinder seals. t
11 Check cylinder piston rods and bushings. t
Electrical System W A B C
1 Test access module, check for damage and make sure it is secure. t
To Next Page
Loading...
Need help?
General
