209
11.14 EN
Particle filter
Hose reel
Impact sensor
Sideshifter
Seat heating
Travel W A B C
1
Note: Any work carried out on the particle filter system must only be
performed by specialist personnel.
2
Particle filter: Clean filter in accordance with the manufacturer's
instructions.
3
Test the particle filter system. Check its setting and check for
contamination, clean if necessary.
4
Measure the soot index according to the manufacturer's
specifications or national regulations.
t
Hydraulic operations W A B C
1 Test the hose reel and check for leaks and damage. t
Electrical System W A B C
1 Check impact sensor is secure and check for damage. t
Hydraulic operations W A B C
1 Test the hose reel and check for leaks and damage. t
2 Check axial play of the front and rear rollers and adjust if necessary. t
3
Check attachment is properly secured to the truck and the
supporting elements.
t
4 Test attachment, check settings and check for damage. t
5 Check sliding blocks are complete. t
6
Check attachment bearing points, guides and stops for wear and
damage, grease and clean these components.
t
7 Check attachment lubrication; clean and lubricate if necessary. t
8 Check hydraulic ports and tighten if necessary. t
9 Test the sideshifter, check settings and check for damage. t
10 Check cylinder seals. t
11 Check cylinder piston rods and bushings. t
Electrical System W A B C
1
Check electrical wiring for damage (insulation damage,
connections). Make sure wire connections are secure.
t
To Next Page
Loading...
Need help?
General
