Juniper E320

Policy Management show Commands ! 141
Chapter 5: Monitoring Policy Management
Classifier control list: *, precedence 1000
filter
Referenced by interfaces:
ATM4/0.5 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Referenced by merge policies:
None
! Example 3—Displays component policies
host1#show policy-list mpl_10
Policy Table
------ -----
IP Policy mpl_10
Administrative state: enable
Reference count: 1
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.1 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
comp_p1
comp_p3
! Example 4—Display rate limit hierarchy in one policy
host1#show policy-list P1
Policy Table
------ -----
IP Policy P1
Administrative state: enable
Reference count: 2
Classifier control list: A, precedence 100, parent-group X
rate-limit-profile A
mark profile A
Classifier control list: B, precedence 100, parent-group X
rate-limit-profile B
mark profile B
Classifier control list: *, precedence 100, parent-group Z