Juniper E320

JUNOSe 7.2.x Policy Management Configuration Guide
140 ! Policy Management show Commands
MPLS Policy routeForMpls
Administrative state: enable
Reference count: 0
Classifier control list: *, precedence 200
mark-exp 2 mask 7
rate-limit-profile mplsRLP5
VLAN Policy routeForVlan
Administrative state: enable
Reference count: 0
Classifier control list: lowLatencyLowDrop, precedence 100
traffic-class lowLatencyLowDrop
color green
mark-user-priority 7
Classifier control list: lowLatency, precedence 100
traffic-class lowLatency (suspended)
Classifier control list: excellentEffort, precedence 100
traffic-class excellentEffort
Classifier control list: bestEffort, precedence 100
traffic-class bestEffort
! Example 2—Displays component policies
host 1#show policy-list comp_p1
Policy Table
------ -----
IP Policy comp_p1
Administrative state: enable
Reference count: 7
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
Classifier control list: C2, precedence 10
filter
Referenced by interfaces:
ATM3/0.3 input policy, statistics enabled, virtual-router vr1
ATM3/0.4 output policy, statistics disabled, virtual-router vr1
ATM3/0.5 secondary-input policy, statistics enabled, virtual-router
vr1
Referenced by profiles:
prof_1 input policy, statistics disabled
Referenced by merge policies:
mpl_10
mpl_11
mpl_12
host1#show policy-list comp_p2
Policy Table
------ -----
IP Policy comp_p2
Administrative state: enable
Reference count: 1
Classifier control list: C1, precedence 90
color red