Juniper E320

Policy Management show Commands ! 139
Chapter 5: Monitoring Policy Management
" mark user priority—Value assigned to 802.1p VLAN user priority bit
" mark DE—DE bit action
! Rule status—Indicates whether the rule is suspended.
! Example
host1#show policy-list
Policy Table
------ -----
IP Policy routeForABCCorp
Administrative state: enable
Reference count: 0
atm-cell-mode: enabled
Classifier control list: ipCLACL10, precedence 75
exception http-redirect
forward
Virtual-router: default
List:
next-hop 192.0.2.12, order 10, rule 2 (active)
next-hop 192.0.100.109, order 20, rule 3 (reachable)
next-hop 192.120.17.5, order 30, rule 4 (reachable)
interface ip3/1, order 40, rule 5
mark tos 125
rate-limit-profile ipRLP25
Classifier control list: ipCLACL20, precedence 125
filter
IPv6 Policy routeForIPv6
Administrative state: enable
Reference count: 0
Classifier control list: ipv6tc67, precedence 75
color red
mark tc-precedence 7
Frame relay Policy frOutputPolicy
Administrative state: enable
Reference count: 0
Classifier control list: frMatchDeSet, precedence 100
mark-de 1
Frame relay Policy frInputPolicy
Administrative state: enable
Reference count: 0
Classifier control list: frMatchDeSet, precedence 100
color red
GRE Tunnel Policy routeGre50
Administrative state: enable
Reference count: 0
Classifier control list: gre8, precedence 150
color red
mark dsfield 20
filter
L2TP Policy routeForl2tp
Administrative state: enable
Reference count: 0
Classifier control list: *, precedence 100
color red
rate-limit-profile l2tpRLP20