JUNOSe 7.2.x Policy Management Configuration Guide
60 ! Merging Policies
Administrative state: enable
Reference count: 1
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.2 output policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p2
IP Policy mpl_8
Administrative state: enable
Reference count: 1
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 80
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
color yellow
Classifier control list: C4, precedence 900
color red
Referenced by interfaces:
ATM5/0.1 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p3
15. Detach p1 from atm 5/0.1. Merge policy mpl_8 is detached and deleted and
only p3 is attached to this interface.
host1(config)#interface atm 5/0.1
host1(config-subif)#no ip policy input p1
host1(config-subif)#exit
16. Display policies to verify that p3 is attached to atm 5/0.1 and mpl_8 is
removed.
host1#show policy-list
To Next Page
Loading...
Need help?
General
