Juniper MX150

Quick Start Guide
MX150
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 3
Step 3: Keep Going | 5
Step 1: Begin
IN THIS SECTION
Mount the MX150 | 2
Connect Power to the Switch | 3
To mount and connect power to the Juniper Networks
®
MX150, and perform initial configuration, you need:
•
Electrostatic discharge (ESD) grounding strap (not provided)
•
One pair of front-mounting bracket (provided)
•
Eight screws to secure the mounting bracket (provided)
•
Four screws to secure the chassis and mounting bracket to the rack (not provided)
•
Screwdriver appropriate for your rack mounting screws (not provided)
•
An AC power cord with plugs appropriate for your geographical location (provided)
•
RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided)

Juniper MX150 Specifications

General

Brand	Juniper
Model	MX150
Category	Network Router
Language	English

Summary

Step 1: Begin

Mount the MX150

Details on physically installing the MX150 device into a rack.

Connect Power to the Switch

Instructions for connecting the MX150 to a power source and powering it on.

Step 2: Up and Running

Configure the Device

Steps for initial device configuration, including IP addressing and services.

Step 3: Keep Going

Safety Warnings Summary

Summary of essential safety warnings for operating and maintaining the device.

Power Cable Warning (Japanese)

Warning regarding the specific power cable provided for the product.

Contacting Juniper Networks

Information on how to obtain technical support from Juniper Networks.