Connect Power to the NFX250
1. Attach a grounding cable to earth ground and then attach it to the chassis grounding points.
NOTE: We recommend grounding for AC-powered systems. An AC-powered device gets additional grounding
when you connect the power supply in the device to a grounded AC power outlet by using the power cord.
The NFX250 device uses a fixed, internal AC power supply.
2. Set the power switch to the OFF (O) position.
3. Insert the power cord plug into the power source outlet.
4. Insert the power cord coupler firmly into the inlet.
5. Set the power switch to the ON (|) position.
6. Verify that the power LED is lit green and on steadily.
Step 2: Up and Running
IN THIS SECTION
Set Parameter Values | 4
Perform the Initial Configuration | 4
3
To Next Page
Loading...
Need help?
General
