Juniper MX10016 - User Manual

Quick Start Guide
MX10016 Universal Routing Platform Quick Start Guide
IN THIS GUIDE
Quick Start Description | 1
Step 1–Preparing the Site for an MX10016 | 2
Step 2–Unpacking the MX10016 | 4
Step 3–Mounting the Router Chassis | 7
Step 4–Installing Line Cards | 11
Step 5–Installing the Front Panel | 14
Step 6–Connecting Power to the Chassis | 16
Step 7–Connecting to the Network | 28
Step 8–Performing Initial Configuration | 29
Safety Warnings Summary | 30
Quick Start Description
This Quick Start contains information you need to install and configure the MX10016 router. For complete installation
instructions, see the MX10016 Universal Routing Platform Hardware Guide at https://www.juniper.net/documentation/.
WARNING: This guide contains a subset of MX10016 safety information. For the complete list of safety
warnings for the MX10016 see the MX10016 Hardware Guide. See MX10016 Universal Routing Platform
Hardware Guide at https://www.juniper.net/documentation/.

Juniper MX10016 Specifications

General

Slot Count	16
Operating System	Junos OS
Product Type	Router
Chassis Type	Modular
Supported Interfaces	1GbE, 10GbE, 40GbE, 100GbE
Routing Engine	MX Series RE
Redundancy	Routing Engine, Switch Fabric, Power Supplies, Cooling System
Power Supply	AC / DC
Cooling	Front-to-back
Operating Temperature	0 to 40°C
Management Interfaces	Console, Ethernet

Summary

Quick Start Description

Preparing the Site for an MX10016

Rack-Mounting Requirements

Specifies the requirements for mounting the MX10016 chassis in standard 19-in. four-post racks.

Clearance Requirements

Outlines the necessary clearances around the chassis for proper airflow and maintenance.

Cooling and Airflow Requirements

Explains the cooling system and airflow path for the MX10016 chassis.

Unpacking the MX10016

Mounting the Router Chassis

Installing the Mounting Hardware

Details the installation of the four-piece mounting bracket set onto the rack.

Mounting the MX10016 Using a Mechanical Lift

Guides the process of lifting and placing the chassis onto the installed mounting brackets.

Installing Line Cards

ESD Point on Chassis Front

Identifies the ESD grounding point on the front of the router chassis for static discharge protection.

Removing the Cover Panel for a Line Card

Explains how to remove the cover panel to expose the line card slot.

Line Card Connectors

Shows the connectors on a line card and how they interface with the chassis.

Inserting a Line Card into the Slot and Rotating the Handles

Details the process of sliding and securing a line card into its designated slot.

Installing the Front Panel

Front Panel Mounting Hardware

Lists the required hardware for attaching the front panel to the chassis.

Attaching Front Panel Brackets

Describes the process of attaching the brackets to the chassis for front panel installation.

Connecting Power to the Chassis

Ground the Chassis

Explains how to connect the chassis to earth ground for safety and EMI compliance.

Install AC Power Supplies

Guides the installation of up to ten AC power supplies into the rear of the chassis.

Install DC Power Supplies

Guides the installation of DC power supplies into the rear of the chassis, noting polarity.

Connecting to the Network

Connecting a Router to a Management Console Through a Console Server

Illustrates connecting the router to a console server for network management.

Connecting a Router Directly to a Management Console

Shows how to connect the router directly to a management console or PC.

Performing Initial Configuration

Safety Warnings Summary