Need help?Do you have a question about the Juniper EX4100-F- 24P/T and is the answer not in the manual?
General| Redundant Power Supply | Optional |
|---|---|
| Ports | 24 x 1GbE PoE+, 4 x 10GbE SFP+ |
| Power Supply | Internal |
| PoE | PoE+ |
| Management | Juniper Mist Cloud, CLI |
| Operating Temperature | 0°C to 45°C |
| Input Voltage | 100-240V AC |
| Operating Humidity | 5% to 90% non-condensing |
Document describes how to identify and remove NV storage from the EX4100-F-24P/T platform.
Document applies only to the EX4100-F-24P/T platform and identifies NV storage components.
Details the Juniper Networks EX4100-F-24P/T Ethernet Switches and their port configurations.
Explains hot-swappable components like power supply and transceivers.
Lists non-volatile devices on the main board, including eUSB and IDEEPROM.
Lists volatile memory components on the main board, such as DDR memory and RTC battery.
Outlines steps to clear volatile storage and remove memory components.
Provides steps to disassemble the chassis and identify NV storage components.
Identifies volatile memory (DDR4) and System CPLD (U33) on the main board.
Identifies non-volatile storage (eUSB) and the RTC battery (BA1).
Identifies the system EEPROM (U21) on the main board.
Identifies Uboot SPI FLASH (U136, U137) and Golden CPLD FW (U192).
To Next Page