Letter of Volatility EX4100-F-24P/T 2/2/2023
UNCLASSIFIED
3.1 POWER DOWN AND REMOVAL OF MEMORY DEVICES
To ensure that no user data or system configurations remain reside on a
EX4100-F-24P/T platform, the following steps must be performed:
1. Power must be removed from the system to clear all volatile storage.
2. Volatile and Non-volatile memory components must be removed
from the system board.
Following section provides the instructions on how to remove these
components in detail.
4 SYSTEM POWER DOWN
Power down the system by removing any connected power cords from power
supply.
4.1 Disassembly of the EX4100-F-24P/T Chassis and Identification of
NV storage
The EX4100-F-24P/T does contain NV storages that is replaceable as well as
it is soldered to the system board. To access the memory for removal, refer to
the following steps:
1. Removing ear-mounts on both left and right side.
2. In-Built Power Supplies in device
Figure 4-1: NON-Removable PSU FRUs
To Next Page
Loading...
