To Next PageTo Next Page
Need help?Do you have a question about the Juniper MX10016 and is the answer not in the manual?
General| Brand | Juniper |
|---|---|
| Model | MX10016 |
| Category | Network Hardware |
| Language | English |
Specifies the requirements for mounting the MX10016 chassis in standard 19-in. four-post racks.
Outlines the necessary clearances around the chassis for proper airflow and maintenance.
Explains the cooling system and airflow path for the MX10016 chassis.
Details the installation of the four-piece mounting bracket set onto the rack.
Guides the process of lifting and placing the chassis onto the installed mounting brackets.
Identifies the ESD grounding point on the front of the router chassis for static discharge protection.
Explains how to remove the cover panel to expose the line card slot.
Shows the connectors on a line card and how they interface with the chassis.
Details the process of sliding and securing a line card into its designated slot.
Lists the required hardware for attaching the front panel to the chassis.
Describes the process of attaching the brackets to the chassis for front panel installation.
Explains how to connect the chassis to earth ground for safety and EMI compliance.
Guides the installation of up to ten AC power supplies into the rear of the chassis.
Guides the installation of DC power supplies into the rear of the chassis, noting polarity.
Illustrates connecting the router to a console server for network management.
Shows how to connect the router directly to a management console or PC.
