Juniper QFX5100-96S - Configuring a QFX5110; Figure 34: QFX5110 VCF with QFX5100-24 Q Leaf Devices

Figure 34: QFX5110 VCF with QFX5100-24Q Leaf Devices
See Also Virtual Chassis Fabric Hardware Overview on page 66•
• Planning a Virtual Chassis Fabric Deployment on page 67
Configuring a QFX5110
You must perform the initial configuration of the QFX5110 through the console port using
the command-line interface (CLI).
Before you begin connecting and configuring a QFX5110, set the following parameter
values on the console server or PC:
•
Baud Rate—9600
•
Flow Control—None
•
Data—8
•
Parity—None
•
Stop Bits—1
•
DCD State—Disregard
Copyright © 2019, Juniper Networks, Inc.104
QFX5110 Switch Hardware Guide