30
E8/E80 – Quick Reference Guide
E8/E80 – Quick Reference Guide
J
These short instructions do not replace the ‘E8/E80 Instructions for
Use’. Make sure you read and observe the safety information and
warnings first in order to avoid hazards.
You can start coffee system rinsing manually at any time.
T Place a receptacle under the coffee spout.
T Press the ‘Pc’ button.
T Press the ‘>’ button.
T Press the ‘Rinse the coffee system’ button to start the rinse
operation.
‘Machine is rinsing’, water flows out of the coffee spout. The
operation stops automatically.
E This chapter applies to the professional fine foam frother and
the fine foam frother.
After each milk preparation, the JURA prompts you to perform a milk
system rinse.
E In programming mode, you can set whether the milk system
rinsing is to be prompted 10 minutes after preparation or initi-
ated automatically (see Chapter 4 ‘Permanent settings in pro-
gramming mode – Milk system rinsing’).
Precondition:‘Rinse the milk system’ is displayed.
T Place a receptacle under the fine foam frother.
T Press the ‘Pc’ button.
T Press the ‘>’ button.
T Press the ‘Rinse the milk system’ button to start the rinse
operation.
‘Milk system is being rinsed’ appears and the fine foam
frother is rinsed. The operation stops automatically.
Rinsing the machine
é
è
Rinsing the fine foam
frother
é
è
To Next Page
Loading...
Need help?
General
Weight and Dimensions
