Jura E8 - Important Safeguards; General Safety Precautions

32
E8/E80 – Quick Reference Guide
T During the first brief interruption, set the setting wheel of
the professional fine foam frother to the Milk position è.
‘Clean the milk system’
T Rinse the container thoroughly and fill the front part with
250ml of fresh water.
T Place this under the fine foam frother and reconnect the
milk pipe to the container.
T Press the ‘Next’ button.
‘Milk system is being cleaned’ appears and the fine foam
frother and the milk pipe are rinsed with fresh water.
The start screen is displayed.
To make sure the professional fine foam frother works properly, and
in the interests of hygiene, it must be dismantled and rinsed daily if
you have been preparing milk. Your JURA will not prompt you to dis-
mantle and rinse the professional fine foam frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully remove the professional fine foam frother from the
Connector System
©
by twisting slightly.
T Dismantle the professional fine foam frother into its individ-
ual parts.
T Rinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 250ml cold water and 1 capful of JURA milk
system cleaner. Then rinse the parts thoroughly.
T Re-assemble the professional fine foam frother.
E Ensure that all individual parts are correctly and firmly
connected to ensure optimum operation of the professional
fine foam frother.
T Firmly attach the professional fine foam frother to the
Connector System
©
.
To make sure the fine foam frother works properly, and in the inter-
ests of hygiene, it must be dismantled and rinsed daily if you have
been preparing milk. Your JURA will not prompt you to dismantle
and rinse the frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
é
è
6
Dismantling and rinsing
the professional fine
foam frother
é
è
Dismantling and rinsing
the fine foam frother