Jura E8 - Cleaning the Fine Foam Frother

31
E8/E80 – Quick Reference Guide
E This chapter applies to the professional fine foam frother and
the fine foam frother.
To ensure that the fine foam frother always works properly, you
must clean it daily when you have been preparing milk.
If the wrong cleaning agent is used, the machine could be damaged
and/or traces could be left behind in the water.
T Use only original JURA maintenance products.
E JURA milk system cleaner is available from specialised dealers.
E To clean the milk system, use the container supplied.
T Press the ‘Pc’ button.
T Press the ‘Clean the milk system’ button.
‘Clean the milk system’
T Press the ‘Start’ button.
T Press the ‘Next’ button.
‘Clean the milk system’ / ‘Milk system cleaner’
T Remove the milk pipe from the milk container or carton.
T Add milk system cleaner to the front part of the container
up to the bottom mark (indicated by 6).
T Then fill with water up to the upper mark.
T Place the container under the fine foam frother.
T If you are using the professional fine foam frother, set the
setting wheel to the Milk Foam position é.
T Connect the milk pipe to the container.
E To connect the milk pipe to the container correctly, the pipe
must be fitted with a connector.
T Press the ‘Next’ button.
‘Milk system is being cleaned’ appears and the fine foam
frother and the milk pipe are cleaned.
Cleaning the fine foam
frother
CAUTION
6
é
è
6