Elektroapparate AG
Technical information
Technical Support
Language
E
ENA 9 One Touch
Author: Patrik Studer Checked: Approved: Docu.-name: Technische_Information_ENA_9_E.doc
L:\Geräte\ENA\ENA_9\Schulungsunterlagen\E\Technische_I
nformation_ENA_9_E.doc
Date: Rev. A: Rev. B: Rev. C: Rev. D: Rev. E: Rev. F:
15.09.2010 19.10.2010 24.11.2010
Page 7/11
15 Decalcification:
§ After reaching the programmed amount of water, according to the water hardness level, the display
shows DE-SCALE / READY
§ Steam will also be calculated with an internal factor
Water
hardness level
°dH AQUADUR
°dH
Liters Message
(When reached the amount of water)
0 = not possible
1 1 ... 7 5 ... 10 220 DE-SCALE / READY
2 8 ... 15 10 ... 15 100 DE-SCALE / READY
3 16 ... 23 15 ... 20 60 DE-SCALE / READY
4 24 ... 30 20 ... 25 40 DE-SCALE / READY
(No acoustic warning)
Conversion factors:
1 °dH = 1.25 °e = 17.86 ppm (CaCO
3
) = 1.78 °f
16 Products:
§ For 2 Cups products, push twice within 2 sec.
§ The amount of coffee water for the 2 CUPS can be programmed individually
§ AROMA BOOST is only defined for a single product
If pressed twice, it will produce 2 ESPRESSI
§ The amount of water can still be changed after the grinding/pre-brewing process by turning the
Rotary Switch
§ Continuous draw off of water stops after max. 500 ml (16.9 oz)
§ Process bar during product draw off
16.1 Coffee water:
§ Amount: Coffee 25 ml ... 240 ml (0.5 oz ... 8.0 oz)
(Display calculating tolerance: 0.5 ... 15.0 oz in 0.5 oz steps)
16.2 Coffee flavour, aroma strength:
§ Possibility to choose the flavour before a draw off by turning the Rotary Switch. The flavour can still
be changed during the grinding process (also backwards).
§ When you prepare an “AROMA BOOST” the maximum possible amount of powder is freshly ground
and extracted to make an extra strong espresso or coffee (display SPECIAL)
Flavour Grinding time
MILD 5.7 sec.
NORMAL 7.2 sec.
STRONG 9.3 sec.