4
IMPRESSA C5 – Quick Reference Guide
Your IMPRESSA no longer has to be de-scaled if you are using CLARIS
plus filter cartridges.
Perform the ‘Using filter’ operation without a break. This will
ensure that your IMPRESSA always produces its best.
Remove the packaging on the CLARIS plus filter cartridge.
Remove the water tank and empty it.
Lift the cartridge holder and insert the filter cartridge into
the water tank, applying a light pressure.
Close the cartridge holder. It will lock into place audibly.
Fill the water tank with cold, fresh tap water and reinsert.
After two months, the filter will cease to work. Monitor the
elapsed time as shown on the date plate on the cartridge
holder.
Precondition: your IMPRESSA must be switched off (standby
mode).
Open the access door.
n l Hold down the Filter button until the Filter indicator n
lights up.
ä l Turn the Rotary Switch until the 3 light segments around the
Rotary Switch lights up.
When the 3 light segments light up, the filter is activated. If
none of the light segments light up, this means that the filter
has not been activated.
m l Press the Rotary Switch to confirm the setting.
The light segment by the switch will now flash.
o
l
l
l
l
l
o
l
o
Using and activating
filter
Using and activating
filter
To Next Page
Loading...
