2
IMPRESSA C9 – Quick Reference Guide
These short instructions do not replace the ‘IMPRESSA C9 Manual’.
Make sure you read and observe the safety information and warn-
ings first in order to avoid hazards.
Precondition: Your IMPRESSA is switched on at the power switch and
the indicator light is illuminated (standby).
Q T Press the On/Off button to switch the IMPRESSA on.
HEATING is displayed.
PRESS RINSE, the maintenance button c lights up.
T Place a receptacle under the coffee spout.
c T Press the maintenance button.
RINSING, the machine rinses.
Preparation stops automatically.
READY appears on the
display.
Your IMPRESSA no longer has to be descaled if you are using CLARIS
filter cartridges.
E Perform the ‘Insert filter’ operation without interruptions. This
will ensure that your IMPRESSA always produces its best.
Precondition:
READY is displayed.
T Open the cover of the Rotary Switch.
k T Keep the Rotary Switch pressed until
RINSE appears on
the display.
g T Turn the Rotary Switch until
FILTER - is displayed.
k T Press the Rotary Switch to enter the programme item.
NO -
g T Turn the Rotary Switch until YES w is displayed.
k T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display to confirm the setting.
INSERT, the maintenance button c lights up.
T Close the cover of the Rotary Switch.
T Remove the CLARIS filter cartridge from the Welcome Pack.
T Remove the water tank and empty it.
Switching on
Using and activating
filter
To Next Page
Loading...
