Do you have a question about the JVC 4VR-5446X/56 and is the answer not in the manual?
Input sensitivity (MM) | 2.5mV |
---|---|
Input sensitivity (line) | 150mV |
Signal to noise ratio (MM) | 70dB |
Output (line) | 150mV |
Power output (quadraphonic) | 20W per channel (8 ohms, 20Hz-20kHz, 0.8% THD) |
Frequency response | 20Hz to 20kHz |
Total harmonic distortion | 0.8% |
Speaker load impedance | 4-16 ohms |
Electrical specifications for the audio amplification stage.
Performance data for the FM reception circuitry.
Performance data for the AM reception circuitry.
Diagrams illustrating the pin configurations of various transistors.
Preparatory steps and conditions required prior to tuner alignment.
Adjustment steps for tracking and sensitivity at lower broadcast frequencies.
Adjustment steps for tracking and sensitivity at higher broadcast frequencies.
FM alignment procedure focusing on the discriminator circuit.
FM alignment procedure for the center tuning meter and distortion.
Procedure for setting quiescent current for audio output transistors.
Method for measuring audio stage bias using a millivoltmeter.
Adjusting the 30kHz sub-channel carrier level for optimal CD-4 signal reproduction.
Calibrating channel separation for CD-4 playback.