Need help?Do you have a question about the JVC AL-E77BK and is the answer not in the manual?
General| Frequency response | 20 Hz - 20 kHz |
|---|---|
| Tracking force adjustment | 1.5 - 2.5 g |
| Platter | 300 mm aluminum die-cast |
| Drive method | Belt-drive |
| Cartridge type | Magnetic cartridge |
| Output voltage | 2.5 mV |
| Output | RCA |
| Speeds | 33 1/3, 45 RPM |
Procedure to check and set the correct line voltage for safe operation.
Guidelines for selecting a suitable installation location for the unit.
Instructions for unplugging the power cord safely.
Warning against inserting foreign objects into the turntable.
Steps for unpacking the turntable and initial setup.
Instructions for installing the drive belt and connecting the turntable.
Recommendations for placing the turntable on a stable surface.
Guidance on stacking and connecting with other JVC units.
Explanation of various indicator lights on the control panel.
Instructions for operating power, clear, and program selection functions.
How to use REPEAT, INDEX, and SKIP buttons for playback control.
Controls for tonearm movement, starting/stopping, speed, and sensor adjustment.
How to use the EP adapter and the Direct Call System (DCS).
Steps for automatic and programmed track playback.
Guide to adjusting the SENSOR knob for accurate playback.
How to preview tunes using Index Play and how to cancel it.
How to play records manually and pause/resume playback.
How to use repeat, skip functions and cancel index play.
How to stop playback and perform synchronized recording with a cassette deck.
Technical details for the motor, tonearm, and cartridge sections.
General specifications including power and dimensions.
Explanation of how the turntable selects programmed tunes using sensors.
Steps for removing the dust cover and front escutcheon.
Procedure for adjusting the tonearm's tracking error (offset).
Adjustments for tonearm lead-in and tune selection sensitivity.
Procedures for adjusting motor speed and replacing the cartridge.
Addresses problems with tonearm movement and tune selection sensitivity.
Steps to suspend the carrier cord correctly.
Steps for fixing the tonearm section in place.
Overview of major part locations on the unit.
Detailed exploded views with part numbers and descriptions.
Parts list for various printed circuit boards.
Diagrams showing parts located on the front and top of the turntable.
List of part numbers for the mechanism assembly components.
Explanation of symbols used to denote designated areas for packing materials.
Diagram showing the locations of individual printed circuit boards.
Explanation of symbols used to denote designated areas for packing materials.
Explanation of symbols used to denote designated areas for accessories.
To Next Page
