Need help?Do you have a question about the JVC QL-A75 and is the answer not in the manual?
General| Motor | DC Servo Motor |
|---|---|
| Drive system | Belt Drive |
| Speeds | 33 1/3, 45 RPM |
| Overhang | 15 mm |
| Cartridge | Not Included |
| Wow and flutter | 0.025% (WRMS) |
| Platter | Aluminum |
| Tonearm | Static balance type |
| Tracking force range | 0 to 3g |
| Signal to noise ratio | 78 dB (DIN-B) |
Step-by-step guide for safely removing the tonearm base unit from the turntable.
Procedure to set the correct vertical tracking angle by adjusting tonearm height.
How to adjust the tonearm elevator for proper stylus tip to record surface clearance.
Method for aligning the cartridge overhang for optimal tracking and reduced distortion.
Steps to properly set the stylus tracking force using the counterweight and dial.
Instructions for setting the anti-skating force to counteract lateral tracking error.
Procedure to calibrate the automatic tonearm lift-up mechanism at the end of playback.
Guidance on adjusting the motor phase for stable quartz-locked rotation, especially after IC replacement.
Diagnostic steps for resolving issues with the tonearm's automatic movement or manual operation.
Troubleshooting guide for when the turntable motor or platter fails to operate correctly.
Exploded view and part list for the turntable's platter, base, and cabinet components.
Exploded view and part identification for the tonearm assembly and its parts.
Exploded view and part list for the turntable's internal mechanism assembly.
Detailed parts list and diagram for the motor drive printed circuit board.
Parts list and diagram for the main amplifier, power supply, and control PC board.
Procedure for safely replacing or installing solderless connectors for power cord attachments.
To Next Page
