V-14FMG3/AV-14FMG3B
8
SPECIFIC SERVICE INSTRUCTIONS
REMOVING T HE REAR COVER
1. Unp lu g t he po we r plu g.
2. As sh own in f igure, remove t he 4 screws marked
!
!!
!
an d a
screw marked "
""
",#
##
#.
3. W ithdr a w t he rear co ver to wa rd you .
REMOVING T HE MAIN PW BOARD
" After removing the rear cover.
1. Slight ly ra is e th e b ot h side s of t he MAIN PW BOARD b y han d
an d r e mo ve t he PWB stop per marked $
$$
$ from the front cabinet.
2. W ithdr a w t he MAIN PW B OARD b ackward.
(If n ecess ary, take off the wire clamp, c onn ect ors etc. )
REMOVING T HE SPEAKER
"
After removing the rear cover.
1. As sh own in figu r e, remove th e 2 screws marked %
%%
%.
2. Follow th e s ame st eps wh en removing th e oth er ha nd sp eak er .
CHECKIN G THE MAIN PW BOARD
1. To ch eck the ba ck side of th e PW B oard.
1) Pu ll out the MAIN PW Bo ard. (Ref er to RE MO VING THE MAIN
PW B oard)
2) Erect the PW Board ve rt ic ally so th at you ca n easily ch eck the
b ack side of th e PW B oard.
[CAUTION]
" When e recting th e PW Boar d, be caref ul s o t hat th ere will b e n o
con tact ing with ot her PW Board.
" Before turning on power, make sure that the CRT earth wire and
oth er co nne cto r are p rope rly c onn ect ed.
WIRE CLAMPING AND CABLE T YING
1. Be sure t o clamp th e wire.
2. Never remo ve th e c able tie use d f or tying th e wire s to ge ther.
Sh ould it be inad ver te ntly r emove d, b e su re to tie th e wires wit h a
new cable tie.
To Next Page
Loading...
