20
Menu item Selectable setting/item
Fader/Balance
Back
Fader/Balance
Reset
Fader 0
Balance 0
Fader : Adjust the front and rear speaker output balance.
♦
F6 to R6; Initial 0
• When using a two-speaker system, set the fader to the center (0).
Balance : Adjust the left and right speaker output balance.
♦
L6 to R6; Initial 0
Press [
5/∞/2/3 ] or drag [ ] to adjust.
Volume Adjust *
1
Adjust and store the auto-adjustment volume level for each source, comparing
to the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix> appears if an FM broadcast is selected as the source.
♦
–12 to +12; Initial 00
Subwoofer Level Adjust the subwoofer output level.
♦
–06 to +08; Initial 00
High Pass Filter
♦
Through
♦
On
: Select when the subwoofer is not connected.
: Select when the subwoofer is connected.
Crossover Select the crossover frequency between the front/rear speakers and the
subwoofer.
♦
80Hz, 120Hz, 150Hz
Amplifier Gain *
2
You can change the maximum volume level of this unit.
♦
Off
♦
Low
♦
High
: Deactivates the built-in amplifier.
: VOL 00 to 30 (Select this if the maximum power of the
speakers is less than 50 W.)
: VOL 00 to 50
Rear Speaker *
3
You can activate/deactivate the rear speakers.
♦
On
♦
Off
: Activate the rear speakers.
: Deactivate the rear speakers.
*
1
For “
DISC/USB
”: You can make the adjustments separately depending on the audio format—Dolby digital/MPEG
Audio and the others.
*
2
The volume level automatically changes to “VOL 30” if you change to <Low> with the volume level set higher than
“VOL 30.”
*
3
This setting takes effect only when Dual Zone is activated. ( 37)
Initial: Underlined
Sound
EN_KW-AVX826[U].indb 20EN_KW-AVX826[U].indb 20 09.2.4 10:50:23 AM09.2.4 10:50:23 AM
To Next Page
Loading...
