JVC GR-AX30U - Page 17

RM-V700U
(provided)
32
PUNRAM PRR RSC Race GNIS
The Time-Lapse function allows automatic sequential
on/off recording at preset time spans. With the
VideoMovie continuously focused on a specific scene
or object, the resulting recording will show subtle
changes (such as shifts in cloud formations, plant
growth etc.) over an extended period of time.
Ml Set SP/EP to "SP".
i Put the VideoMovie into the Record-Pause mode.
i Press REC TIME to select the recording time.
— The following sequence of time settings is
displayed with each press of REC TIME:
+ 1/4S + 1/25 —--» 1S
~--— (regular recording mode)
eee
Viewfinder
i Press INT. TIME to select the interval time.
— The following sequence of time settings is
displayed with each press of INT. TIME:
15S —» 30S —» {MIN —» 5MIN
: seni ay af
Viewfinder
(regular recording mode)
8 Press START/STOP to start the Time-Lapse
recording. The selected recording time and interval
will alternate automatically.
® The tally lamp functions in the same way as in
Self-Timer shooting.
To retease the Time-Lapse mode:
[ When "-" js not blinking:
Press INT. TIME and REC TIME continuously until
tm" and" &" go off.
When "~" is blinking:
Press Start/Stop to stop the blinking, then press the INT.
TIME and REG TIME continuously until "ta" and "©"
go off.
L
Notes:
@ When shooting in the Time-Lapse mode, the
elapsed time counter reading may be incorrect. This
is not due to any defect of the unit.
w During steps —] or @, if the VideoMovie's
PROGRAM AF is set to "SD" (Salf-Timar mada). the
Self-Timer 15S mode will be engaged.
Compartment door
Sliding jatch
| PLAYBACK |
By using the provided cassette adapter (VHS Playpak:
C-P6U), a VHS video cassette recorded with this
VideoMovie can be played back with any VHS video
recorder. When the VHS-C video cassette is installed
in the cassette adapter, it is fully compatible for both
recording and playback on any VHS video recorder.
The C-P6U cassette adapter is battery-powered and
will automatically perform tape loading and unloading.
Note:
Only compact video cassette tapes marked VHS-C
can be used with the cassette adapter.
"Inserting the battery into the cassette’
adapter a Sree oe .
Wi Remove the battery cover by sliding it up.
Install one "AA(R6)" size battery as shown.
EI Reattach the cover.
Playback‘on the VCR 0
(1] Open the compartment door by sliding the latch.
[2] Insert the compact video cassette.
[3] Close the compartment door. The tape is loaded.
[4] Insert the cassette adapter into the VCR.
[5] Playback the tape.
Note:
During special-effect playback (slow motion, still
frame, etc.), the picture may vibrate or noise bars may
appear on the screen.
Il Slide the sliding jatch.
— The tape will be unloaded and the compartment
door will open.
Insert your finger into the hole on the underside of
the adapter, push the cassette up from below and
remove it.