JVC GR-AX40EG User Manual

Notes:
Do not repeatedly recharge a battery pack without
tully discharging it ts service life will decrease. Use
the REFRESH feature after every & charges.
® Even if @ battery pack is fully charged, but is not
used, it naturally discharges gradually: Be sure to
recharge the batiery pack just before using it, or the
day before you intend to use it
& This unit becomes warm due to the flow of electric
current inside. Operate il in places having good
ventilation. Do not allow it to discharge in a
container, such as a bag, etc. Blocking the
ventilation causes the temperature inside the unit to
‘ise, possibly resulting in a damaged unit
i eltner recharging oF discharging is stopped in the
middle. of the process, remove the battery pack
before unplugging the AC cord.
‘= This unit incorporates an over-discharging protection
Circuit, however, immediately remove the battery
pack from this unit after discharging has been
completed to maintain the battery pack’s capacity.
= if used near @ radio, the Multi AG Charger/Adapter
‘may interfere with reception.
© Be sure to connect the AC power cord and unplug
the DC cord before-charging or discharging the
battery pack.
™ Betore storing the battery pack for a long period it is
recommended to discharge it.
= The REFRESH feature will not function if the power
status of a battery pack is discharged (No power
remaining}.
1 With a just purchased battery pack, or with @ battery
pack that has been stored for a long period, the
‘CHARGE indicator may nat light properly. In such a
‘case, remove and reattach the battery pack again,
then do the recharging procedure. The CHARGE
indicator should light during recharging to indicate,
the battery pack is normal. If this is not the result,
consuil your nearest JVC dealer.
A WORD ON THE EXCLUSIVE BATTERY PACKS
‘The battery packs are nickel-cadmium batteries and nickel-metal hydride batteries. Be sure to carefully read
the caution attached to the battery pack.
‘Temperature ranges:
‘The recharging time is based on room temperature of 20°C.
“The lower the temperature, the longer the recharging time.
For charging: 10°C to 35°C
For operating:0°C to 40°C
PREPARATIONS (Cont'd)
CLOCK {LITHIUM) BATTERY INSERTION
Necessary for clock and date/time settings.
* Switch off the unit's power and remove the power
supply unit before inserting or removing the-clock
Hf Open the clock batisry. compartment cover while
pressing the release tab.”
Bi Insert the provided tithium battery with the plus, (+)
side up and push it in.
* When removing the battery, insert a pointed non-
metallic object between the battery and the
compartment (@)) to pull it out,
& Close the compartment cover until it clicks in place.
Warning on lithium battery
8 Dispose of used battery promptly.
© Keep away from children.
# Do not disassemble and do not dispose of it in
fire,
(See Waring on lithium battery, e @. 2)
SETTING DATE/TIME
Before adjusting the date and time for the first time or
after replacing the clock battery.
i Set the power switch to "CAMERA".
Press SET, — The day blinks,
i Prese SELECT to choose the correct day.
Bi Repeat steps Il and I to set the month, year, hour
and minute.
Press SET to start the clock.
For storing:-10°C 10 90°C
—Now that the setting is completed, blinking stops.
Both the date and time will be displayed for
confirmation, after which the date remains
displayed by itself,
Notes:
® While the date or time are blinking, the clock does
not keep time.
= When re-adjusting the data, press. SET and
SELECT to correct them. After adjustment is
completed, both the date and time appear for
confirmation, then the display. returns to the mode
before conecting.
ee = When PROGRAM AE is eet to "AUTO MODE
Date.....Dato setting is performed. LOCK" (<> P 18}, the date and time are displayed
3 immediately after adjustments, after which the
7 display automaticatty changes to Auto Date record
Tine moder P. 14)

JVC GR-AX40EG Specifications

General

Brand	JVC
Model	GR-AX40EG
Category	VCR
Language	English