EN 7
2
1
3
Using the battery pack
1
Hook-on the battery pack’s top end to the
camcorder. (Charging procedure, 墌 pg. 10)
2 Push in the battery pack until it locks into
place.
To remove the battery pack
Slide BATT. RELEASE and pull out the battery
pack.
QUICK OPERATION GUIDE (D.S.C.)
1 Set the System Select Switch to “D.S.C.”.
2 Set the Power Switch to “PLAY”.
— A still image stored in memory appears.
3 Press “W” or “T” of the Page Button to select
the still image you want to view.
(For more details, 墌 pg. 55.)
•The viewfinder switches off automatically to
save power when the LCD monitor is
opened at an angle of over 45 degrees.
•The LCD monitor turns on/off when it is
opened/closed at approx. 45 degrees.
1 Slide the LENS COVER Open/Close Switch
to open the lens cover.
2 Set the System Select Switch to “D.S.C.”.
3 Set the Power Switch to “CAMERA”.
— The power indicator will light and an
image will appear.
4 Press the SNAPSHOT Button.
— A still image is shot and is stored in the
camcorder’s memory.
(For more details, 墌 pg. 48)
•The viewfinder switches off automatically to
save power when the LCD monitor is
opened at an angle of over 45 degrees.
•The LCD monitor turns on/off when it is
opened/closed at approx. 45 degrees.
SUPPLY POWER
PLAYBACK
SHOOTING
2
1
BATT. RELEASE
3
1
2
4
Hook on.
Push in.
Power Switch
Set to “PLAY”
System Select Switch
Set to “D.S.C.”
Page Button
SNAPSHOT Button
Power Switch
Set to “CAMERA”
LENS COVER
Open/Close
Switch
System Select Switch
Set to “D.S.C.”
To Next Page
Loading...
Need help?
General
