EN
ENEN
EN
##
####
##
Master Page: Right
Still images can be dubbed from a tape to a memory
card.
1
Load a cassette. (墌 pg. 15)
2
Load a memory card. (墌 pg. 16)
3
Set the VIDEO/MEMORY Switch to “VIDEO”.
4
Set the Power Switch to “PLAY” while pressing
down the Lock Button located on the switch.
5
Set “ COPY” to “ON”. (墌 pg. 31, 40)
6
Press PLAY (4/9) to start playback.
7
At the point you want to dub, press PLAY (4/9)
again to engage Still Playback.
8
To dub the image, press SNAPSHOT.
● The ”” indication appears during
dubbing.
● The selected image is stored in the memory
card.
NOTES:
● If SNAPSHOT is pressed in step 8 when a memory
card is not loaded, the message “COPYING
FAILED” is displayed.
● If an image recorded on the tape using “WIDE
MODE” (墌 pg. 37) is dubbed to a memory card,
the WIDE mode identifying signal is not dubbed
with it.
● To use Playback Special effects with a video image
you wish to dub, perform up to step 8 using the
remote control (provided). (墌 pg. 58)
● Images are dubbed in 640 x 480 pixels.
Dubbing Still Images Recorded On
A Tape To A Memory Card
SNAPSHOT Button
Play/Pause Button
(PLAY (4/9))
VIDEO/MEMORY Switch
ADVANCED FEATURES
GR-D200US.book Page 55 Friday, April 11, 2003 1:05 PM
To Next Page
Loading...
