EN
ENEN
EN
$%
$%$%
$%
Master Page: Right
This camcorder can be used as a WebCam via USB
connection.
1
Make sure all necessary software (provided) are
installed in your PC and all units are turned off.
2
Connect the camcorder to your PC using the USB
cable.
3
Set the VIDEO/MEMORY Switch to “MEMORY”.
4
Set the Power Switch to “A” or “M” while
pressing down the Lock Button located on the
switch.
5
Turn on the PC.
● “” appears on the screen.
● If the PC is not powered on, the camcorder
does not enter the Web Camera mode.
6
When finished, turn off the PC first, then the
camcorder. Disconnect the USB cable from the
camcorder and PC.
NOTES:
●
●●
● It is recommended to use the AC Adapter as the
power supply instead of the battery pack.
(墌
墌墌
墌 pg. 11)
● Use the provided software PIXELA ImageMixer to
capture video in real time.
● You can also use the camcorder for web
conference by using Microsoft Windows®
NetMeeting® and signing up for MSN Hotmail.
● In the Web Camera mode, the following buttons
cannot be operated: E-MAIL, SNAPSHOT, INDEX,
NAVI, NAVI STORE, the Recording Start/Stop
Button.
Using The Camcorder As A
WebCam
To USB
To USB connector
USB cable
(provided)
USB-equipped PC
Refer to the instruction manuals of the PC and
provided Software.
ADVANCED FEATURES
GR-D200US.book Page 67 Friday, April 11, 2003 1:05 PM
To Next Page
Loading...
Need help?
General
