EN11
Memory card
Card Cover
Loading A Memory Card
The provided MultiMediaCard is already inserted in the
camcorder when you receive the camcorder.
1
Make sure the camcorder’s power is off.
2
Open the card cover (MEMORY CARD).
3
Insert the memory card clipped edge first.
•Do not touch the terminal on the reverse side of the
label.
4
To close the card cover, push it until you hear a click.
To Unload A Memory Card . . .
.... in step 3 push the memory card, which then comes
out of the camcorder automatically. Pull it out and
close the card cover.
NOTES:
●
Be sure to use only SD Memory Cards marked “ ”
or MultiMediaCards marked “ ”.
●
Some brands of memory cards are not compatible with
this camcorder. Before purchasing a memory card ,
consult its manufacturer or dealer.
●
Before using a new memory card, it is necessary to
FORMAT the card.
pg. 47.
●
Even if a memory card is inserted in the camcorder, the
camcorder may not recognize it. In this case, remove the
memory card once and insert it again.
ATTENTION:
Do not insert/remove the memory card while the
camcorder is turned on, as this may cause the memory
card to be corrupted or cause the camcorder to
become unable to recognize whether or not the card
is installed.
Clipped edge
Label
To Next Page
Loading...
Need help?
General
