20
EN
SNAP MODE – FULL
NEGA
PIN–UP
FRAME
* There is the sound effect of a shutter closing.
Snapshot (For Tape Recording)
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1 Set the VIDEO/MEMORY Switch to “VIDEO”, then
set the Power Switch to “ ” while pressing down the
Lock Button located on the switch. Pull out the
viewfinder fully or open the LCD monitor fully.
2 Press the MENU wheel in. The Menu Screen
appears.
3 Rotate the MENU wheel to select “ CAMERA”.
Press it and the CAMERA Menu appears.
4 Rotate the MENU wheel to select “SNAP MODE”,
then press it.
5 Rotate the MENU wheel to select the desired
Snapshot mode, then press it.
Rotate the MENU wheel to select “ RETURN” and
press it twice. The Menu Screen closes.
SNAPSHOT RECORDING
1 Press SNAPSHOT.
If you press during Record-Standby . . .
..... “PHOTO” appears and a still image will be
recorded for approx. 6 seconds, then the
camcorder re-enters the Record-Standby mode.
If you press during Recording . . .
..... “PHOTO” appears and a still image will be
recorded for approx. 6 seconds, then the normal
recording resumes.
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect
similar to serial photography. (Interval between still
images: approx. 1 second)
NOTES:
● To remove the shutter sound, 墌 “BEEP” on pg. 30.
● If Snapshot recording is not possible, “PHOTO” blinks
when SNAPSHOT is pressed.
● If Programme AE with special effects (
墌 pg. 38) is
engaged, certain modes of Programme AE with special
effects are disabled during Snapshot recording. In such
a case, the icon blinks.
● If SNAPSHOT is pressed when “DIS” is set to “ON”
(
墌 pg. 29), the Stabiliser will be disabled.
● To dub images recorded on a tape to a memory card,
墌 pg. 61.
● The Motor Drive mode is disabled when “REC
SELECT” is set to “ / ” in the Menu
Screen (
墌 pg. 31).
● If “REC SELECT” is set to “
/ ” in the
DSC Menu Screen, still images are recorded on the
memory card as well (640 x 480 pixels).
● During playback as well, all snapshot modes except
Nega mode are available when “ COPY” is
set to “OFF” in the Menu Screen (
墌 pg. 32).
● When a headphone set is connected to the PHONE
connector, the shutter sound is not heard from the
speaker, however it is recorded onto the tape.
Display
Lock Button
VIDEO/MEMORY Switch
(Open the LCD monitor
to access this switch.)
FULL
Snapshot mode with no
frame*
FRAME
Snapshot mode with
frame*
NEGA
Nega mode*
PIN-UP
Pin-Up mode
Menu Screen
BASIC RECORDING
Recording On Tape (cont.)
Power Switch
SNAPSHOT Button
MENU Wheel
To Next Page
Loading...
