EN
61
COPY OFF
IMA EG
NA GATIONVI
–
6
SP
6
SP
Play/Pause Button (
4
/6)
Display
Power Switch
Lock Button
Dubbing Still Images Recorded On A Tape
To A Memory Card
Still images can be dubbed from a tape to a memory
card.
1 Load a memory card ( pg. 13) and cassette
( pg. 12).
2 Set the VIDEO/MEMORY Switch to “VIDEO”, then
set the Power Switch to “ ” while pressing down
the Lock Button.
3 Press the MENU wheel in. The Menu Screen
appears. Rotate it to select “ VIDEO” and press it.
The VIDEO Menu appears.
4 Rotate the MENU wheel to select “
COPY” and press it. The Sub Menu appears. Rotate it
to select “IMAGE” and press it. Selection is complete.
5 Rotate the MENU wheel to select “ RETURN”
and press it twice. The normal playback screen
reappears.
6 To select a video image to be dubbed, start
playback by pressing
4
/6. At the moment you find
the image you wish to dub, press it again to engage
Still Playback.
7 To start dubbing, press SNAPSHOT. The selected
image is stored on the memory card.
•“ ” blinks during dubbing.
NOTES:
● If SNAPSHOT is pressed in step 7 when a memory
card is not loaded, the message “COPYING FAILED” is
displayed.
● If an image recorded on the tape using the WIDE mode
( pg. 30) is dubbed to a memory card, the WIDE
mode identifying signal is not dubbed with it.
● To use Playback Special Effects with a video image you
wish to dub, perform up to step 7 using the remote
control (provided) (
pg. 65).
● Images are dubbed in 640 x 480 pixels.
MENU Wheel
SNAPSHOT
Button
VIDEO/MEMORY Switch
(Open the LCD monitor
to access this switch.)
To Next Page
Loading...
