JVC GR-DVL160EG User Manual

2-15
2.5 CHECKUP AND ADJUSTMENT OF MECHANISM PHASE
Fig. 2-5-1
<Rotary encoder>
Set the “■” of the rotary
part at the tapped hole
as shown in the figure.
<Worm wheel> (Note 2)
Set the worm wheel so
that its locating hole
meets the hole on the
main deck assembly.
<Main cam gear
/Brake control plate>
After fitting the main cam
gear and brake control plate
together,set them together
so that their locating holes
meet the hole on the main
deck assembly.
<Connect gear 2> (Note 2)
Set the connect gear 2 so
that its locating hole meets
the hole on the main deck
assembly.
<Sub cam gear>
Set the sub cam gear
so that its locating hole
meets the hole on the
main deck assembly.
This state represents
that the mechanism is
in the EJECT mode,
which is the “mechanism
assembly mode”.
<Connect gear> (Note 2)
Set the connect gear so
that its locating hole meets
the hole on the main deck
assembly.
Note 1
Note 1:
Since the connect gear 2 is tightly fixed to the main deck
by caulking, adjust its phase with the connect gear and
sub cam gear.
Note 2:
The part that needs phase adjustment by the hole on the main
deck assembly must exactly be set as the specified phase.
There is a fear that some part is installed in a wrong phase
because assembling of the mechanism is automated. If so,
set every part in the correct phase whenever the mechanism
is reassembled.

JVC GR-DVL160EG Specifications

General

Recording Format	MiniDV
Optical Zoom	16x
LCD Screen Size	2.5 inches
Optical Sensor Resolution	680, 000 pixels
Image Stabilizer	Electronic
Display Type	LCD
Recording Media	MiniDV Tape
Type	MiniDV
Image Sensor	CCD
Optical Sensor Size	1/4 inch
Focus Adjustment	Automatic, Manual
Shooting Programs	Spotlight, Sand & snow, Portrait mode, Sports mode
White Balance	Auto, Manual
Microphone	Built-in
Connector Type	USB, FireWire
Battery Type	Li-ion
Effective Pixels	340, 000
Viewfinder	Color
Video Format	Mini DV
Interface	IEEE 1394 (FireWire), USB