46
EN
AUTOMATIC EDITING TO VCR
8 Rewind the tape in the camcorder to the
beginning of the scene you want to edit and press
PAUSE (6).
9 Point the remote control towards the VCR’s
remote sensor and press VCR REC STBY (q6), or
manually engage the VCR’s Record-Pause mode.
10
Press the Recording Start/Stop Button on the
camcorder. Editing proceeds as programmed, right
through to the end of the last registered scene.
• When dubbing is complete, the camcorder enters
the Pause mode, and the VCR enters its Record-
Pause mode.
• If you do not register an Edit-Out point, the tape will
be dubbed all the way to the end automatically.
• If you operate the camcorder during automatic
editing, the VCR will enter its Record-Pause mode
and automatic editing will stop.
11
Engage the Stop modes for the camcorder and
the VCR.
To make the R.A.Edit counter display disappear,
press ON/OFF on the remote control.
NOTES:
● Pressing ON/OFF on the remote control clears all
settings registered during Random Assemble Editing.
● When the editing cable is connected to the remote
control’s Pause In connector during dubbing, make sure
the remote control is pointed at the VCR’s sensor, and
the path between the two is unobstructed.
● Random Assemble Editing may not function properly
when using a tape including several duplicated time
codes (
墌 pg. 18).
1
2
3
4
5
6
7
8
00
:2
5
~
02:05
––––
07:18
~
08:31
–– ––
––––
–– ––
0
3
:
33
~
05:53
13:15
15:
:
55
~
~
~
~
16:29
––––
––
––
––
––
––
–– –– ––
NIOUTMODE
09:30
~
1
6
:
30
9
:
39
TOTAL
CODETIME
PAUSE
VCR REC STBY
ON/OFF
Recording Start/Stop Button
Random Assemble
Editing Menu
Remote Sensor
RM-V700U
(optional)
USING THE OPTIONAL REMOTE CONTROL UNIT
(cont.)
To Next Page
Loading...
Need help?
General
